15 PIN UNKNOWN CONNECTOR
Pin | Name | Description |
---|---|---|
1 | TEXT | Video text signal from TMG; set to inverse of GR, except in double high-resolution mode. |
2 | 14M | 14M master timing signal from the system oscillator. |
3 | SYNC* | Displays horizontal and vertical synchronization signal from IOU pin 39. |
4 | SEGB | Displays vertical counter bit from IOU pin 4; in text mode, indicates second low-order vertical counter; in graphics mode, indicates low-resolution. |
5 | 1VSOUND | One-volt sound signal from pin 5 of the audio hybrid circuit (AUD). |
6 | LDPS* | Video shift-register load enable from pin 12 of TMG. |
7 | WNDW* | Active area display blanking; includes both horizontal and vertical blanking. |
8 | +12V | Regulated +12 volts DC; can drive 300mA. |
9 | PRAS* | RAM row-address strobe from TMG pin 19. |
10 | GR | Graphics mode enable from IOU pin 2. |
11 | SEROUT* | Serialized character generator output from pin 1 of the 74LS166 shift register. |
12 | NTSC | Composite NTSC video signal from VID hybrid chip. |
13 | GND | Ground reference and supply. |
14 | VIDD7 | From 74LS374 video latch; causes half-dot shift high. |
15 | CREF | Color reference signal from TMG pin 3; 3.58 MHz. |
Note:
The signals at the DB-15 on the Apple IIc are not the same as
those at the DB-15 end of the Apple III, Apple IIGS, and Macintosh II.
Do not attempt to plug a cable intended for one into the other.
Note:
Several of these signals, such as the 14 MHz, must be buffered
within about 4 inches of the back panel connector--preferably inside a
container directly connected to the back panel.
Contributor: Joakim Ögren
Source:
Apple Tech Info Library 1419: Apple IIc, External Pinouts at Apple TIL homepage
Copyright © The Hardware Book Team 1996-2001.
May be copied and redistributed, partially or in whole, as appropriate.
Document last modified: 2000-07-08